Where to buy potato chip cutter

Go down

Where to buy potato chip cutter

Post  dwdaswell on Thu Sep 27, 2018 4:34 pm

vOperation adjustment of buy potato chip cutter:
http://www.potato-popcorn-machine.com/potato-slicing-machine/
The machine knife consists of a fixed slicer and a replaceable wire cutter. When the slicing knife works alone, it can be cut into pieces, and when the cutting is processed, the cutting knife set can be processed into a wire or a strip. When slicing, loosen the wing nut on the side of the eccentric handle, and pull the handle inward to make the slice thin. Otherwise, the piece becomes thicker. Before replacing the knife set, loosen the wing nut and pull the handle to the most. After pushing the knife set to be replaced, tighten the upper knob and then pull the handle outward until the lower end of the movable clamp is tightly attached to the group, then tighten the wing nut. (Note: every time you change the knife
When you are in the film, you should operate in this order)
Maintenance and precautions of buy potato chip cutter:
http://www.potatomachinery.ru/2018/08/24/%D0%BC%D0%B0%D1%88%D0%B8%D0%BD%D0%B0-%D0%B4%D0%BB%D1%8F-%D0%BD%D0%B0%D1%80%D0%B5%D0%B7%D0%BA%D0%B8-%D0%BA%D0%B0%D1%80%D1%82%D0%BE%D1%84%D0%B5%D0%BB%D1%8F/
1. Before use, the direction of rotation should be consistent with the direction of the mark. If it is inconsistent, the source of the point should be adjusted.
2. Before use, the ground wire should be placed at the ground mark to ensure personal safety.
3, remember to wash the cut vegetables, exclude non-vegetable hard objects (such as metal, bricks, etc.), so as not to cause blade damage.
4. When not in use for a long time, the blade should be removed to remove impurities and be kept in oil.
5. This machine uses centrifugal force to push the work of cutting vegetables. Therefore, when the manual rotation speed is not suitable, the ideal efficiency is not achieved. Special attention: If the blade accidentally breaks, stop immediately and find the broken part to avoid being eaten into the dish. (It can be sucked by magnets, and all the processed parts must be thrown away when necessary. The blade is damaged, the individual wires are thickened or there are continuous knives.) Welcome new and old users to give valuable advice.

dwdaswell

Posts : 2220
Join date : 2014-01-07

View user profile

Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum