Various series of concrete mixer pump

Stirring effect is good or bad, not only with the concrete mixer parts operation important relationship, and routine maintenance of equipment has a direct relationship. Concrete mixer parts working conditions are relatively poor as concrete mixer parts are generally cantilever agitator placement and stirring shaft is relatively long; suffered moment and torque than the larger the bearing to withstand greater partial load, resulting in bearing wear sometimes because of a gap after the bearing seal wear mobile block machine, slurry and more immersed into the bearing. bearing wear exacerbated addition stirrer working relative movement of the material is large, so that the material has a strong agitator abrasive if this is uneven abrasion, the agitator will cause an imbalance. sometimes because the agitator or tank wall adhesive material could not be cleared up, the stirring resistance increases, causing mechanical vibrations and noise. operators and maintenance personnel to conduct regular maintenance on equipment and maintenance, to improve the working conditions of pouring agitation avoid mechanical failure.

Henan Daswell Machinery Co., Ltd,is a professional manufacturer and trader specializing in the research, development and production of construction machinery for nearly 30 years. Our main products are as follows:block making machine,concrete pump for sale,We will provide you with the best product and service.

Concrete mixer parts should be set at a flat position, with square wooden paving the front and rear axles, the tire put high overhead cement mixer, avoid walking occurs when running. Concrete concrete mixer parts should implement secondary leakage protection, after returning to work before the power is turned on, must be carefully checked by a qualified empty trial think, can be used. Commissioning tests should Drum speed is appropriate, under normal circumstances, empty the proportion of car speed car(after charging) 2-3 turn slightly faster, such as a difference of more, the ratio should be adjusted to move the wheel and drive wheel.