How to Install and Replace the Energy Saving Ball Mill

Energy saving ball grinding machine changes the intrinsic grinding machine structure. Its body and ground plank are an integral whole. So when fixing, it can be lowered on a plane surface once only. Use double tiered roller axletree with centripetal spherical surface as the support of the host axletree can reduce energy cost by 30%. The intrinsic grille pattern forcing evacuation is instead by over fall pattern controlling one. This can improve the milling of the granule and the quantity dealt with is reduced by 15-20%.

Ball mill is one of super-fine grinding mill widely used in industries. Energy-saving ball mill, which Is one type of ball mill. Energy-saving ball mill’ s liner is used to protect the cylinder, so that the cylinder will not ba directly impacted and rubbed by the grinding body and materials. Energy-saving ball mill’s liner is easy to wear, when you install and replace it , please pay attention to the following items.

1, Clean the grime before installing.

2, When you install energy-saving ball mill liners, you should coat 1:2 cement mortar between the cylinder wall and the liner, and tighten the bolt when the liner is still wet. Wipe the gap between the liners with sand and paste.

3, When fix liner bolts, you should be carefully mat seal to prevent leakage pulp.

4, You should check and tidy the liner before installing it and promise that it is smooth and tidy.

5, If the liner has front and back sides, don’t install liner’s back side outward.

6, When install compartment plate, you should firstly put all the bolts well, and then tighten the bolts gradually in three times.

7, Cylinder liner should not form an annular gap.

8, Solidification of cement mortar must get the strength requirements then can you put materials in to trial.

powder making plant: http://www.ft-dryer.com/products/Powder-production-line.html