Flame Temperature Control of Concrete Mixing Plant

1, before start the forced concrete mixer, check whether there's a rotating part along with a barrel collision phenomenon, for example collision small concrete batching plant, which needs to be timely modified.

Henan Daswell Machinery Co., Ltd,is a professional manufacturer and trader specializing in the research, development and production of construction machinery for nearly 30 years. Our main products are as follows:SICOMA twin shaft compulsory concrete mixer,concrete batching plants,concrete mixer,blocking making machine,concrete pump,etc.

2, reducer ought to be injected in to the oil before using, discharging gear and sliding bearing can also be ought to be implanted oil.

3, clean the miscellaneous materials in barrel, the cylinder spacing system is locked, after which start the device, as with a start following the discovery from the running direction doesn't satisfy the needs, ought to be quickly stop the energy supply, may lead the arbitrary two phase exchange position, after which restart.

4, put concrete mixture in to the barrel, close the cylinder cover, adjust the timing of relay based on the stirring time (stop the energy when modifying).

5, start the motor, the spindle drives the stirring shovel operation, reaches the set time automatic parking.

6, when discharging to prevent, after which is going to be likely to handle undo postural constraints, after which rotating the hands wheel, made up of a earthworm wheel drives the barrel is rotated to facilitate discharge position, stops rotating, after which start the device to ensure that the important from the spindle could be released in the materials, before the material discharge clean stop running from the spindle, rotating the hands wheel helps make the material barrel totally reset.

7, clean barrel of forced concrete mixer, you should use either water or sand to wash the carrel.